Sealey SMC02 - Manual (Page 3)

3.3 cHarGinG a neGatiVe eartHeD Battery:
3.3.1 Ensure that the black clamp on the clamp lead is not
touching the battery or the fuel line.
3.3.2 Connect the positive (+) red clamp to the positive (+)
battery post and connect the negative (-) black clamp
to the negative (-) battery post or vehicle chassis.
3.4 cHarGinG a PositiVe eartHeD Battery:
3.4.1 Ensure that the red clamp on the clamp lead is not
touching the battery or the fuel line.
3.4.2 Connect the negative (-) black clamp to the negative
(-) battery post and connect the positive (+) red clamp
to the positive (+) battery post or vehicle chassis.
3.5 Battery not connecteD to a VeHicLe.
3.5.1 Before connecting or disconnecting the battery leads,
disconnect the power lead from the mains power supply.
3.5.2 Connect the (+) red clamp to the positive (+) battery
post and connect the (-) black clamp to the negative
(-) battery post.
4. oPeration
4.1 connect cHarGer to Mains PoWer suPPLy.
4.1.1 Plug the charger into the mains power supply. The
charger will automatically go into standby mode and
the standby LED will illuminate.
4.2 cHarGinG MoDe seLection.
Repeatedly pressing the MODE button will cycle the
charger through the following options MODE1,
MODE2, and MODE3. Stop pressing when the LED
adjacent to the desired mode lights up.
4.2.1 If the Mode button is pressed again during charging
the charger will switch to the next charging mode and
will function in that mode. However, once the battery is
fully charged and if the charger remains connected,
the charger will switch to float charge mode and
will remain in this mode even if the user selects
another mode. This protects the battery from being
damaged.
Original Language Version
SMC02.V2 Issue No.1 31/10/13 © Jack Sealey Limited
Socket
Fully Charged Green LED Charging Red LED Fault Red LED Power On Green LED
Mode Selection Button
Charging Batteries < 14Ah Charging Batteries > 14Ah *5°C Charging Mode Battery Repair Mode
Indicators
Modes (Red) LED’s
1 2 3 4
A
B
C
Fig.1
Fig.2
* Do not Charge a frozen battery
3.2 Battery PerManentLy instaLLeD in a VeHicLe.
3.2.1 Before connecting or disconnecting the battery leads,
disconnect the power lead from the mains power supply.
3.2.2 Identify the polarity of the battery terminals which are
usually marked on the battery casing. If it is not clear,
the positive battery post is usually a larger diameter
than the negative post.
3.2.3 Identify the polarity of the battery pole connected to
the chassis (earth). This will normally be the negative
terminal.
BS 1363/A
UK 3 pin plug
4.3 MoDe 1 DescriPtion (14.4V/1.0a)
4.3.1 This mode is suitable for charging small batteries with a
capacity below 14Ah. Press the MODE button until the
LED adjacent to the motorcycle symbol is illuminated.
Charging will automatically begin with a current of
0.8A ± 10% and the 'charging' LED will illuminate. This
LED will remain on throughout the entire charging
process until the battery is fully charged up to 14.4V ±
0.25V. At this stage the 'charging' LED will extinguish and
the 'fully charged' LED will illuminate. The trickle charge
current now becomes available for battery
maintenance.