Vitek VT-8517 ST - Manual (Page 5)

5
ENGLISH
into the blender bowl (3), set the switch (7)
to the position “P” and hold the switch (7) for
1-3 seconds; repeat 8-12 times.
– If you want tot mix water with ice (no more than
10 cubes sized 2.5 cm x 2.5 cm x 2.5 cm), first
chop the ice as described above and then set
the switch (7) to the position “II” and let the
blender operate for 1-2 minutes.
ATTENTION! Continuous operation time of
the blender should not exceed 2 minutes;
after that switch the unit off and let it cool
down for at least 2 minutes.
CLEANING AND CARE
After the unit operation is finished, switch the
blender off by setting the operation mode switch
(7) to the “0” position and unplug it.
• Remove the blender bowl (3) from the motor
unit (6) by turning it counterclockwise.
• Remove the measuring cup (1) from the lid (2).
• Remove the lid (2) from the bowl (3) taking it
by the ledge and take the processed products
out of the bowl (3).
• Wash the bowl (3) preliminarily.
• Turn the bowl (3) upside down and unscrew
the knife block (5) using the correspond-
ing grooves on the measuring cup (1) (see
pic. 1). Remove the sealing gasket from the
knife block.
Rotate the knife block counter-
clockwise to unscrew.
ATTENTION: The cutting edges of the knives
are very sharp and dangerous. Handle them
very carefully.
• Wash the bowl (3), the knife block (5) and
the sealing gasket with warm water and soft
detergent and dry them.
• Clean the unit body with a soft damp cloth and
then wipe it dry.
• Do not use coarse sponges, abrasives and
solvents to clean the blender.
• Do not immerse the motor unit (6) into
any liquids; do not wash it in a dishwash-
ing machine.
• Do not put the removable parts of the
blender in a dishwashing machine.
• Install the sealing gasket into the knife block
(5).
• Install the knife block (5) into the blender
bowl (3). Use the measuring cup (1) to turn
the knife block (5) counterclockwise as far
as it will go.
• When installing the knife block (5), do not
apply excessive effort to avoid damage of
the sealing gasket.
STORAGE
• Perform the requirements of the CLEANING
AND CARE section before taking the unit away
for storage.
• Keep the unit in a clean dry place out of reach
of children.
DELIVERY SET
Table blender – 1 pc.
Measuring cup – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220-240 V ~ 50 Hz
Maximum power: 900 W
Bowl capacity: 1.5 l
The manufacturer preserves the right to change
the specifications of the units without a prelimi-
nary notification
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
VT-8517.indd 5 17.02.2016 17:19:54