Vitek VT-1262 PK - Manual (Page 4)

4
ENGLISH
IRON VT-1262 PK
The•iron•is•intended•for•ironing•clothes•and•bed-
ding•and•for•vertical•steaming•of•fabrics.
DESCRIPTION
1.• Water•spray
2.• Water•inlet•lid
3.• Continuous•steam•supply•knob
4.• Burst•of•steam•button
5.• Water•spray•button
6.• Handle
7.• Power•cord•protection
8.• Heating•element•pilot•lamp
9.• Base
10.• Water•tank
11.• Temperature•control•knob
12.• Self-clean•button
13.• Maximum•water•level•mark
14.• Soleplate
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA, to install
RCD, contact a specialist.
SAFETY MEASURES
Before•using•the•electrical•unit,•read•this•instruc-
tion•manual•carefully•and•keep•it•for•future•refer-
ence.
Use• the• unit• for• its• intended• purpose• only,• as•
specified• in• this• manual.• Mishandling• of• the• unit•
may•lead•to•its•breakage•and•cause•harm•to•the•
user•or•damage•to•his/her•property.
• Before• switching• the• unit• on,• make• sure• that•
your• home• mains• voltage• corresponds• to• the•
iron•operating•voltage.
• The•power•cord•is•equipped•with•a•«europlug»;•
plug•it•into•the•socket•with•a•reliable•ground-
ing•contact.
• To• avoid• risk• of• fire,• do• not• use• adapters• for•
plugging•the•unit•in.
• To•avoid•mains•overloading,•do•not•switch•sev-
eral• electrical• appliances• on• with• high• power•
consumption•at•a•time.
• Do•not•use•the•iron•outdoors•and•in•places•with•
high•humidity.
• Place•the•iron•on•a•flat•stable•surface•or•use•a•
stable•ironing•board.
ATTENTION! The surfaces of the iron warm up
during operation. Avoid contact of open skin
areas with the iron hot surfaces or outgoing steam
to avoid burns.
• Do•not•fill•the•water•tank•with•scented•liquids,•
vinegar,• starch• solution,• descaling• reagents,•
chemicals,•etc.
• Do•not•switch•the•unit•on•in•places•where•aero-
sols• are• sprayed• or• highly• flammable• liquids•
are•used.
• Provide•that•the•power•cord•is•not•on•the•iron-
ing•board•and•make•sure•that•it•does•not•touch•
hot•surfaces•and•sharp•edges.
• Never• leave• the• unit• connected• to• the• mains•
unattended.• During• breaks• in• operation,• put•
the•iron•on•the•base•(in•vertical•position).
• Before• plugging/unplugging• the• iron,• set• the•
temperature• control• knob• to• the• minimum•
position•and•switch•the•continuous•steam•sup-
ply•off.
• Always•unplug•the•iron•if•you•are•not•using•it.
• Always• take• the• power• plug• out• of• the• mains•
socket•before•filling•the•water•tank•with•water.
• The• water• inlet• lid• should• be• closed• during•
ironing.
• To•unplug•the•iron,•always•hold•the•power•plug,•
never•pull•the•power•cord.
• To• avoid• electric• shock,• do• not• immerse• the•
iron,•the•power•cord•and•the•plug•into•water•or•
any•other•liquids.
• Before• taking• the• iron• away,• let• it• cool• down•
completely•and•pour•out•the•remaining•water.
• Pour•out•water•from•the•water•tank•only•after•
unplugging•the•iron.
• Clean the unit regularly.
• Do not touch the unit body and the power
plug with wet hands.
• Do• not• allow• children• to• touch• the• iron• body•
and•the•power•cord•during•operation.
• Do• not• leave• children• unattended• to• prevent•
using•the•unit•as•a•toy.
• For•children•safety•reasons•do•not•leave•poly-
ethylene• bags,• used• as• packaging,• unat-
tended.
ATTENTION! Do not allow children to play with
polyethylene bags or packaging film.
Danger of suffocation!
• Never• use• the• unit• if• the• power• plug• or• the•
power• cord• is• damaged,• if• the• iron• works•
improperly,•after•it•was•dropped•or•in•case•of•
leakage.
• Do•not•attempt•to•repair•the•unit.•Do•not•disas-
semble•the•unit•by•yourself,•if•any•malfunction•is•
detected•or•after•it•was•dropped,•unplug•the•unit•
and•apply•to•any•authorized•service•center•from•
the• contact• address• list• given• in• the• warranty•
certificate•and•on•the•website•www.vitek.ru.
IM VT-1262.indd 4 10.06.2016 11:47:56