Remote control information – Epson 400 Series User Manual

Page 68

Advertising
background image

68

Notices

■

The lamp(s) in this product contain mercury. Please consult your state and local regulations

regarding disposal or recycling. Do not put in the trash.

■

Allow the lamp to cool for one hour before replacing it.

■

Unplug the projector during lightning storms or when not in use for extended periods.

■

Don’t place the projector or remote control on top of heat-producing equipment.

■

If you use the projector in a country other than where you purchased it, use the correct power cord
for that country.

■

Don’t stand on the projector or place heavy objects on it.

■

Don’t use the projector outside of the required temperature range of 41 to 95 °F (5 to
35 °C). Doing so may cause an unstable display and could lead to projector damage.

■

Don’t store the projector outside of the required temperature range of 14 to 140 °F
(–10 to 60 °C) or in direct sunlight for long periods of time. Doing so may cause damage to the
case.

WARNING: The cords included with this product contain chemicals, including lead,
known to the State of California to cause birth defects or other reproductive harm. Wash
hands after handling
. (posted in accordance with Proposition 65 in Cal. Health & Safety
Code § 2549.5 et seq)

Remote Control Information

You can operate the projector by remote control via a line-of-sight infrared (IR) receiver at the front
and rear of the projector. The projector may not respond to remote control commands under the
following conditions:

■

There is an object between the remote control and the IR receiver on the projector.

■

Ambient light is too bright.

■

Certain types of fluorescent lighting are used.

■

Other equipment that emits infrared energy, such as a radiant room heater, is in the room.

If you experience problems, try the following:

■

The remote control’s batteries may be low on power; replace them.

■

Dim the ambient lighting and/or turn off any fluorescent lights.

■

Close any window coverings and/or move the projector out of direct sunlight.

■

Turn off other equipment that emits infrared energy.

PowerLite Cinema 400.book Page 68 Friday, July 7, 2006 2:24 PM

Advertising