Epson GT-30000 - Manual (Page 8)

Scanner Selection
4
6. If Setup instructs you to reboot your computer, you must do so before using the driver. Click Finish to
close Setup.
Scanner driver setup is complete.
Scanner Selection
Most ISIS applications enable you to select the scanner to use from among all scanners whose drivers you
have installed. Scanner selection is often accomplished by a File menu command. If the application uses the
built-in ISIS user interface for scanner selection, you should see a dialog box similar to this:
1. Locate the EPSON GT-30000 and click to select it.
2. Click Setup. The Configure Device Settings dialog box appears. (If you have never before set up this
scanner, the Configure Device Settings dialog box also appears if you click OK.)
The driver attempts to locate the scanner on the SCSI bus. If successful, it displays the scanner’s SCSI
address in the Selected Device box.
If the scanner was not properly connected or was not turned on when you clicked Setup, correct the
problem and then click Rescan Bus. When the driver succeeds in locating the scanner, its SCSI address
appears in the Selected Device box.
3. Choose the page size you most often will scan from the Default Page Size list. Note that you can
change the page size to any available size at any time while using the scanner—this is the setting the
scanner will use by default.
4. Click OK to close the Configure Device Settings dialog box.
Scanner selection is complete.