Edimax Technology Broadband Router - Manual (Page 43)

42
Parameters Description
General General options allow you to setup the network neighborhood name and user accounts.
Share Share options allow you to add/modify the folder/disks that you want to share.
Advanced
Advanced options allow you to set the default sharing options and the properties of FTP
server.
NAS Tools
NAS tools allow you to manage the partitions of the USB storage device. You can add,
remove, or format the partition of the USB storage device.
NAS Status
The NAS status shows the status of both USB ports. When you plug a USB storage
device into the USB ports, it will show the status of the current valid disk and partition of
this device.
Click on one of the NAS selections and proceed to the manual
’s relevant sub-section
Note: The maximum file size of a single file is less than 2GB when using a partition which owns FAT16/32 file system
due to operating system limitation, whereas for a partition which owns EXT2/3 file system, the file size is up to 4GB.
2.9.1 General
General setting is used to set sharing information of samba and can be used to manager users' information, include add,
edit and delete users' information.
Parameters Description
Name Set the host name that shows in network neighborhood.
Workgroup Set which network neighborhood group that you want to join.
Description
A brief description for this NAS router. This will show at the detailed information of network
neighborhood.
Add Account
Click “Add” and fill the information of the Account Manager Add page to add a new user
account.
Edit Account
If you want to edit an account from the "Account List Table", select the account you want to
edit in the table and then click "Edit".
Remove Account
If you want to remove some accounts from the "Account List Table", select the accounts
you want to remove in the table and then click "Delete Selected". If you want to remove all
accounts from the table, just click "Delete All" button. If you want to clear the selection and
re-select again, just click
“Reset”.
You can now configure other advance sections or start using the router (with the advance settings in place)