Silvercrest SKT 2000 B1 - Manual (Page 45)

SKT 2000 B1 43
• When deciding where to place the
appliance on the floor, maintain a
minimum distance of 0.5 m from other
appliances or the wall.
• If you are mounting the appliance on the
wall, only the wall hooks supplied
should be used. It must then be ensured
that air can circulate freely around the
convector. The minimum distance
between the floor and the lower edge of
the appliance is 10 cm.
• If you are mounting the appliance on the
wall, it must not be flammable and
should be strong enough for this
purpose.
• Never operate the appliance in rooms
where there is a risk of explosion or in
the vicinity of flammable gases or
liquids.
• Always check that air can freely enter
and escape. Heat might otherwise build
up inside the appliance.
4.6 Protection against injury
Warning! To avoid injury, please
observe the following information.
• Ensure that it is not possible for anyone
to trip over or to get caught up in or step
on the mainscable.
• Once hot, if you wish to transport the
appliance, switch it off, pull out the
mains plug, and wait until the appliance
has cooled down. Otherwise you could
burn yourself on the hot surface.
4.7 For the safety of your child
Warning! Children often cannot
assess dangers correctly and are
injured as a result. Please therefore
observe the following:
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.
4.8 Material damage
Caution! To avoid material damage,
please observe the following conditions.
• When setting up on the floor, check that
the feet are fitted correctly (see
“5.1 Assembling the appliance for set-
up on the floor” on page 43) - otherwise
the floor might be scratched or
scorched.
5. Unpacking and setting up
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
5.1 Assembling the appliance for set-up
on the floor
1. Screw the feet 4 to the underside of the
convector using the short screws
provided. 2 screws are inserted
diagonally per foot.
RP100157 Konvektor Timer LB1 Seite 43 Mittwoch, 11. Juni 2014 12:30 12