Preparing the product for use / cleaning and care, Temperature levels, Automatic switch­off – Silvercrest SFW 100 B2 User Manual

Page 34: Cleaning and care

Advertising
background image

34 GB/MT

Preparing the product for use / Cleaning and Care

Selecting the temperature:

Just before using the foot warmer, set it to the

highest temperature setting (setting 6). This will
cause the foot warmer to warm up quickly.

The foot warmer can of course be used at any

time if it is switched off. Its teddy plush lining
will warm your feet even if an electric socket is
nowhere near.

When operat-

ing the foot warmer for several hours,
we recommend setting the control
unit to the lowest temperature setting
to prevent overheating of the feet
and subsequent potential skin burns.

Temperature levels

Set the required temperature level on the
control

2

.

Level 0:

Off

Level 1:

minimum heat

Level 2–5: customised heat
Level 6:

maximum heat

Automatic switch­off

Note: The foot warmer switches itself off automati-
cally after about 90 minutes. The function display

3

then starts to flash.

Then select the setting 0 and after about
5 seconds, reset the foot warmer to the desired
temperature setting to switch it on again.

Note:
Switch the foot warmer off (setting 0) and pull the
mains plug out of the mains socket if the foot warmer
is not to be used after it has switched off automati-
cally.

Cleaning and Care

DANGER TO

LIFE BY ELECTRIC SHOCK! Al-
ways remove the power plug from

the socket before cleaning the foot warmer.
Otherwise there is a risk of electric shock.

Use a dry, lint-free cloth for control unit

2

cleaning and care.

RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Never immerse the control unit

2

in water or other liquids. It may otherwise be
damaged.

Use a damp cloth and if necessary a little mild
detergent to clean small stains on the foot
warmer.

RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Do
not use chemical cleaning or scour-

ing agents to clean the foot warmer and con-
trol

2

. The foot warmer and control unit

2

may otherwise be damaged.

RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Please note that the foot warmer

must not be washed in a machine, dry-cleaned,
wrung out, tumble-dried, mangled or ironed.
The foot warmer It may otherwise be damaged.

Do not wash.

Do not bleach. Do not use any
cleaning agents containing bleach
(such as heavy duty detergents).

Do not dry in a tumbler dryer.

Do not iron.

Do not dry clean.

The removable teddy lining

1

can

be washed by hand. Use a mild

Cleaning and Care / Storage / Disposal / Warranty / Service centre

Advertising