Silvercrest Luxury Heated Mattress Pad - Manual (Page 29)

33 GB/MT
Please note that, for safety reasons, the electric
underblanket must not be used in the event of a
fault and must be sent to the service centre ad-
dress given below.
Preparing for use
Placing the electric
underblanket
Starting at the foot end, spread out the electric
underblanket over the mattress so that the plug-
in connector
7 is approximately at the level of
the shoulders (see Fig. B).
Note: The area of the head is not heated.
Guide the mains plug of the plug-in connector 7
through the slot in the side part 8 and then
connect the control unit 1 to the electric un-
derblanket by plugging the two parts of the plug-
in connector
7 together (see Figs. B and C).
Then pull the side part as you would a fitted sheet
over the sides of your mattress. The electric
underblanket is designed so that it fits 90 x
200 cm as well as 100 x 200 cm mattresses.
Then place the bottom sheet as usual over the
electric underblanket, so that the electric under-
blanket lies between the mattress and the bot-
tom sheet.
Ensure that the electric underblanket is completely
flat and that it does not become drawn together
or folded during use.
Switching on / off
Switching on:
Press the ON / OFF switch 4 on the control
unit 1 to switch on the electric underblanket.
When switched on, the display 2 illuminates
and shows all its segments for approx. 3 seconds.
Then the display 2 shows the following basic
setting:
Temperature setting for the body zone: 0
Automatic switch-off time: 1h (= 1 hour)
Temperature setting for the foot zone: 0
Switching off:
Press the ON / OFF switch 4 on the control
unit 1 to switch off the electric underblanket.
When switched off, the light and the display 2
cease to illuminate.
Operation
Setting the temperature
Press the button for setting the temperature of
the body zone
6 .
Press the button for setting the temperature of
the foot zone
3 .
Setting 0: OFF
Setting 1: Minimum heat
Settings 2–8: Customised heat
Setting 9:
Maximum heat
Note: Switching sequence of the temperature
settings: 0–9–8–7–6–5–4–3–2–1–0–9 …
Selecting the temperature
Note: This electric underblanket has a rapid
heat-up feature.
Switch the electric underblanket on approxi-
mately 30 minutes before going to bed and
cover it with the top sheet and other bedding.
By doing this you will keep all the heat in.
Set the control unit to the highest temperature
setting (setting 9). This will cause the electric
underblanket to warm up quickest.
For use over several hours, set the control unit
1 to the lowest temperature setting (setting 1)
for the body and the foot zones.
Note: This electric underblanket has an automatic
switch down feature. After a period of approx. 3
hours at temperature settings 9, 8 or 7, the electric
underblanket automatically switches down to set-
ting 6.
Safety system / Preparing for use / Operation
66378_silv_Waermeunterbett_Content_LB5.indd 33 15.06.11 10:00