Silvercrest SHLF 2000 A1 - Manual (Page 10)

8
5.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch
towards the
middle and pull
out the battery
compartment.
2. Remove the old battery if present.
Note: Please observe the instructions for
disposal (see “9.2 Disposable/
rechargeable batteries” on page 11).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery
compartment. The negative pole of the
battery must point upwards.
4. Slide the battery compartment back in
again.
6. Operating
6.1 Displays
The selected function is shown in the display
10 .
A Swivel function is switched on
B Automatic mode. The appliance
automatically adjusts the heat output to
the room temperature. The appliance
switches off as soon as the room
reaches the required temperature.
C Low heat. The appliance operates at
1000 watts
D High heat. The appliance operates at
2000 watts
E Operating time
F Display of room temperature
G Display of set required temperature
As soon as the appliance is working the
indicator light
18 comes on.
6.2 Remote control
The appliance can be operated using the
control panel
2 or the remote control 19 .
The numbers in the text below refer to the
control panel
2 and the remote control 19 .
6.3 Switching the appliance on and
off
1. Insert the mains plug into a wall socket
that complies with the technical data (see
“3. Technical data” on page 4).
2. Set the mains switch 8 to I to switch the
appliance on.
The mains switch 8 and the display 10
light up.
3. To switch the appliance off completely,
set the mains switch 8 to 0.
–
F
A B C D
E
G
RP74284 HL mit FB LB4 Seite 8 Freitag, 25. Mai 2012 5:45 17