Silvercrest SWKT 3000 A1 - Manual (Page 6)

- 4 -
Temperature regulator in the boiling range
• The devices switches off automatically and the
operating light r goes out as soon as the water is
at a full boil. The ON/OFF switch e springs out.
In order to keep the water warm after bringing it to
a boil, set the temperature regulator
y in the keep
warm range.
Press the ON/OFF switch e down, until it snaps in.
Temperature regulator in the keep warm range
The left end of the keep warm range indicates the
lower temperature. The right end of the keep warm
range indicates the higher temperature.
(The water does not start boiling in the keep warm
range!).
• After reaching the desired temperature, the ap-
pliance switches off the heating process. The
ON/OFF switch
e and the operating lights r
remain switched on.

Because the device is equipped with a heat
maintenance function, the device automatically
begins reheating as soon as the water tempe-
rature falls below the set temperature.
The appliance heats until the desired tempera-
ture is reached. Make sure that the appliance
does not automatically switch on to the keep
warm function. Therefore, do not leave the
appliance unsupervised!
• As soon as the kettle u is lifted from the base
t , the ON/OFF switch e jumps out and the
operating lights r switch off.
• In order to halt the heating process, push the
ON/OFF switch e up again. The operating
light r goes out then as well.

Avoid setting the temperature regulator y in
the transition range, as the water can start boi-
ling on account of varying filling levels.
Cleaning and Care

Danger!: Do not open any part of the
housing. There are no operating elements in-
side. An open housing can create the risk of
a life-threatening electrical shock.
Never submerse any parts of the device in
water or other liquids! This can create the
risk of a life-threatening electrical shock if
residual liquid comes into contact with
powered components.
Before cleaning the device, ....
• First pull the power plug out of the power socket
and let the device cool completely.
• Clean the exterior surfaces and the power cord
with a slighly damp cloth. Always dry the device
well before using it again.
• Never use any cleansers, abbrasive substances
or solvents. These can damage the device.
In the event of calcium deposits
• Purchase a decalcifying agent suitable for use
with food containers from a household goods
stores (e.g. coffee machine decalcifier).
• You can use a suitable product from a
specialised dealer for the stainless steel
container bottom.
Removing / replacing the spout screen
• Open the lid q completely.
• Press down on the edge of the spout screen o
from above in order to remove it toward the insi-
de.
• Clean the spout screen o with a lightly
moistened wash cloth.
• After cleaning, insert the spout screen o from
above and press it firmly into place.
IB_68892_SWKT3000A1_LB6 26.07.2011 13:42 Uhr Seite 4