Silvercrest SHT 2000 A1 - Manual (Page 63)

SHT 2000 A1 61
4. To switch the appliance off, press the
On/Off button 16 or 22.
The appliance will continue to run for a
short period and then switch off.
5. To switch the power supply off
completely, set the mains switch 5 to
“OFF”.
Any values you have set will be lost
when doing so.
6.4 Setting the heat output
1. To select a heating setting, press the
function selector 11 or 21 repeatedly
until the required heat setting appears in
the display 10:
– Low heat: The appliance operates at
1,000 watts
– High heat: The appliance operates at
2,000 watts
– Frost protection mode: The appliance
will prevent the room temperature
from dropping below the frost line.
– Fan mode: Fan without heater.
6.5 Selecting the temperature
1. Select one of the two heating settings.
2. Use the button “+” 14 or 18 to increase
the set temperature up to a maximum of
35 °C.
3. Use the button “-” 15 or 17 to reduce
the set temperature down to a minimum
of 5 °C.
The set temperature is shown in the
display 10.
The heater switches off as soon as the room
reaches the set temperature. The fan
continues to run for several seconds to
prevent a build-up of heat.
If the room temperature falls below the set
temperature, the heater and fan switch on
again automatically.
6.6 Setting the operating time
The appliance has a timer with which you
can set the required operating time. The
maximum operating time is 23 hours ans
59 minutes. The appliance switches off
automatically once the operating time has
expired.
RP75978 Heiztower LB1 Seite 61 Mittwoch, 29. August 2012 3:44 15