Elo TouchSystems 1925L Series - Manual (Page 15)

2-11
Step 4-Connecting the Speaker Cable
N OTE : If you do not wish to connect the speaker cable, go to step 5.
• To use the built in speakers, you need to connect the speaker cable. Connect
the speaker cable to the speaker port inside the back of your touchmonitor.
• Connect the other end of the cable to the speaker connector on your PC.
Step 5-Connecting the Power Cable
N OTE : The monitor is equipped with both AC and DC power connectors. The monitor is
shipped with only an AC power cable.
Depending on where you live, you will use either the European or US/Canadian
power cable.
• Connect the female end of the power cable to the power port on the
touchmonitor.
• Route the cable through the cable management clip.
N OTE : To protect your equipment against risk of damage from electrical surges in the power
line, plug the touchmonitor’s power cord into a surge protector, and then connect the
surge protector to a grounded AC electrical outlet.
Speaker port
Connections on underside
Speaker cable
Connections on underside
AC power
Power cable
IEC60320-1
connector
6mm coaxial connector
DC power
(100-240V 50-60Hz
or 12V DC)