EMC Qlogic QLA23xx User Manual

Page 40

Advertising
background image

3

3-8

EMC Fibre Channel with QLogic HBAs in Windows Hosts

Configuring an EMC Boot Device

7. Some servers use SCSI CD-ROM drives. If your server has a SCSI

CD-ROM, repeat steps 5 and 6 to select the driver for the SCSI
controller. If your controller is not on the list, obtain the driver on
diskette from the vendor.

8. If you want to specify drivers for other devices installed in your

system, do so; otherwise press

ENTER

at the Additional Devices

screen to continue with Windows installation.

9. After completing Windows installation, reinstall the QLogic

driver using the steps under Installation Procedure for Windows NT
Hosts
on page 2-15
.

Windows 2000

The HP ProLiant BL20p G2 Windows 2000 Installation procedure is described
under HP ProLiant BL20p G2 Windows 2000 Installation on page 3-9.

1. Boot the installation CD-ROM. (On some servers, it might be

necessary to use the Windows 2000 installation diskettes to start
the installation procedure.)

When the installer starts, a message appears at the bottom of the
screen, prompting you to press

F6

to load any other third-party

drivers.

Press

F6

.

2. After a few moments, the installer stops to let you add additional

devices. A screen message will tell you that the setup program
cannot determine the type of one or more mass storage devices.

From this point, press S to specify additional devices.

3. Insert the QLogic driver diskette into the drive and press

ENTER

.

4. Select the model adapter that you have installed from the list that

appears. Be sure to choose the correct model series for the HBA
you have installed (QLA2300, for example) and press

ENTER

.

The driver loads and you are brought back to the Additional
Devices

screen.

5. If you want to specify drivers for other devices installed in your

system, do so; otherwise press

ENTER

at the Additional Devices

screen to continue with Windows installation.

6. After completing Windows installation, reinstall the QLogic

driver using the steps under Installation Procedure for Windows
2000 and Windows 2003 Hosts
on page 2-15
.

Advertising
This manual is related to the following products: