EMC Qlogic QLA23xx - Manual (Page 60)

3
3-28 EMC Fibre Channel with QLogic HBAs in Windows Hosts
Configuring an EMC Boot Device
2. After Fast!UTIL loads, the display depends on whether there are
multiple QLogic HBAs installed:
• If there is only one QLogic HBA, the Fast!UTIL Options
menu appears.
• If there are multiple QLogic HBAs, a list of addresses occupies
by those HBAs appears. Use the arrow keys to select the
desired HBA; then press
ENTER . The Fast!UTIL Options menu
appears.
3. Select Configuration Settings from the menu.
4. Select Selectable Boot Settings from the Configuration Settings
menu.
The first Boot Port Name entry should already be configured (as
described under Configuring the HBA Boot BIOS on page 3-20).
If you want another SP port to be accessible as a potential boot
path to the current owner SP, select the next Boot Port Name
entry, and in the Device window select the CLARiiON port
WWN from which you want to boot.
5. If you have other HBAs for which you want to assign Boot Port
Name entries, you can press ESC to go back to the main menu,
save changes, and select another HBA as shown in step 2. If the
other HBA you wish to configure has its own
CTRL-Q BIOS
prompt, reboot the server and configure that HBA's Boot Port
Name
entries as you have done here.
6. Trespass the LUN and repeat steps 1 through 5 to configure any
paths over which you want to be able to boot the LUN from the
other SP.