Emerson Radio CKT9087 - Manual (Page 22)

2 1
Receiving Calls
Notes:
• Make sure that the RINGER switch is set to the HI(High) or LOW position. The
phone will not ring if the RINGER switch is set to the OFF position.
• If the radio is playing, the radio will automatically mute when a call is received.
• If you answer the phone on the first ring the Caller ID information will not appear
on the display.
When the phone rings lift the handset as usual and speak into the mouthpiece.
Adjust the handset volume control if necessary.
Call Waiting
If you subscribe to Call Waiting service you will hear an audible signal during a
phone call to alert you that someone else it trying to call you. To put the first caller
‘on hold’, press the FLASH button on the handset and speak briefly to the second
caller. Then press the FLASH button again to return to the first caller.
Making Calls
Note: If the radio is playing, it is not necessary to shut it off or lower the
volume. The radio mutes automatically when you lift the handset from the
base unit.
• Lift the handset and dial the number as usual. Don’t forget to dial a “1” before
the area code if necessary.
To dial stored numbers:
• To dial a number stored in M1, M2, or M3, simply press the appropriate button.
• To dial a number stored in memory “0” through “9”, first press the MEMORY
button and then press the appropriate number button.
Last Number Redial Memory
The last number that you dialed is automatically stored in the Last Number Redial
Memory. This is useful in case your call is not answered, or you get a ‘busy-signal’.
Simply press the REDIAL button and the last number will be automatically redialed.
CKT9087_090606.p65 6/9/2006, 10:56 21