Silvercrest SUP 128 A1 - Manual (Page 22)

19 SUP 128 A1
GB
IE
♦ Use I◂◂ or alternatively ▸▸I or to select the desired track.
♦ Press PROG. or PROGRAM again to store the track in program
position P01. The display shows the next program slot P02.
♦ Use the buttons I◂◂ or ▸▸I to select the track you want to save in program
slot 02 and then press the PROG. or PROGRAM button. The display shows
the next program slot P03.
♦ Repeat these steps until your list is complete.
♦ Press the ▸II/■ or ▸II button to fi nish programming and start playback.
♦ Use the I◂◂ or ▸▸I buttons to switch between the programmed tracks.
NOTE
► After programming 10 tracks, FULL will briefl y appear on the display and
playback will start automatically.
Deleting a list
♦ To delete the list, hold down the ▸II/■ button for about two seconds or
press the ■
button.
♦ Then press the PROG. or PROGRAM button or change the operating
mode. PROG no longer appears in the display.
AUX-IN operation
The record player is equipped with an AUX-IN socket which allows you to
connect an external audio device (e.g. MP3 player) using a 3.5 mm jack cable
and play back your music via the record player.
♦ Connect a 3.5 mm jack cable (available from specialist dealers) to the
AUX-IN socket and the audio output of your external audio device.
♦ Press the AUX button or to switch to AUX-IN operation.
♦ Start playback of the external audio device.
♦ Control the playback volume on the external audio device and the
external amplifi er.
IB_60308_SUP128A1_LB3.indb 19 08.04.14 09:32