Trimming without add-ons – Silvercrest SHBS 1000 A1 User Manual
Page 12
9
SHBS 1000 A1
GB
♦
You can use the slide switch
2
to make fi ne adjustments to the required cut
length
7
. For example, if you want to cut your hair to 22 mm length, take a cut
length add-on
7
for hair lengths of 22-24 mm and push the slide switch
2
for
fi ne length adjustment upwards as far as possible (0.5 mm).
NOTE
►
Variable adjustment of the fi ne adjustment downwards increases the cut
length to 22.5 mm (with fi ne adjustment 1.0 mm); to 23 mm (with fi ne
adjustment 1.5 mm) or to 24 mm (with fi ne adjustment 2.5 mm).
Cut length
add-on
7
(mm)
Cut length* with fi ne length adjustment (mm)
0.5
1.0
1.5
2.0
2.5
4 - 6
4
4.5
5
5.5
6
7 - 9
7
7.5
8
8.5
9
10 - 12
10
10.5
11
11.5
12
16 - 18
16
16.5
17
17.5
18
22 - 24
22
22.5
23
23.5
24
28 - 30
28
28.5
29
29.5
30
* Please note that the cut length can deviate from the stated length depending
on the angle of cut.
♦
Switch the hair and beard trimmer on by pressing the ON - OFF switch
3
.
♦
Run the hair and beard trimmer slowly through your hair.
♦
When doing so, hold the appliance so that the selected cut length add-on
7
is
as fl at as possible against your scalp.
♦
Always cut from your neck towards the top of your head, or from your forehead
and temples upwards towards the middle of the head.
Trimming without add-ons
WARNING
►
The trimmer block
is very sharp. There is a risk of personal injury!
You can cut your hair to lengths between 0.5 mm and 2.5 mm without using a
cut length add-on
7
. Move the slide switch
2
to the required length to fi ne-
adjust the cutting length.
NOTE
►
Depending on how you hold your hair and beard trimmer and the resulting
angle, the cut length can vary from the lengths stated in this operating
manual and marked on the add-on/appliance.
IB_86722_SHBS1000A1_LB4.indb 9
IB_86722_SHBS1000A1_LB4.indb 9
18.03.13 16:49
18.03.13 16:49