Silvercrest SMA 550 A1 - Manual (Page 55)

52 SMA 550 A1
GB
Cleaning and Care
DANGER - RISK OF ELECTRICAL SHOCK!
► Before cleaning it, disconnect the plug from the mains power socket!
Otherwise there is the risk of receiving an electric shock!
► NEVER open any housing parts. There are no user-serviceable elements
inside. When the housing is open, there is the risk of receiving a potentially
fatal electrical shock.
NEVER immerse the appliance in water or other liquids! This would
bring about the risk of a potentially fatal electric shock upon the
next use of the appliance should moisture be present in the voltage
conducting elements.
WARNING - RISK OF PHYSICAL INJURY!
► Let the appliance cool down before cleaning it. Risk of burns!
WARNING - PROPERTY DAMAGE!
Do not clean the appliance or parts of it in the dishwasher!
If you do so, the appliance will be damaged beyond repair.
► Do not use abrasive or caustic cleaning agents. These can attack the
surface and damage it beyond repair.
NOTICE
► Ideally, clean the appliance directly after cooling, so that milk residues can
not dry onto it.
For the fi rst coarse cleaning put some water and a little mild detergent into
the carafe (the whisk used 4/8 is still fi tted). Thereby, pay heed to the
MIN and MAX
- markings.
Start the appliance so that the whisk ploughs 4/8 through the water.
Afterwards, rinse the appliance out with copious clean water.
For a thorough cleaning, proceed as follows:
■ Remove the whisk 4/8 from the appliance to clean it and clean the inside
of the appliance with warm water. Add a little detergent. Wipe the interior
with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse the appliance out with copious clean water.
■ Pull the sealing ring 3 off of the lid 1 and clean both parts in mild soapy
water. Remove detergent residues with clean water and dry both parts well.
Push the sealing ring 3 back onto the lid 1, so that the outwardly facing
sealing lip is located at the bottom of the lid 1 and the inwardly facing seal-
ing lip engages in the groove of the lid 1.
IB_100076_SMA550A1_CH.indb 52 IB_100076_SMA550A1_CH.indb 52 01.04.14 16:40 01.04.14 16:40