Powerfix Z16531 - Manual (Page 7)

7 GB
Operation / Cleaning and care / Disposal
2. Adjust the impact force to suit the materials,
staples or nails.
3. Press the operating lever 1 down firmly.
Examplesofuse:
The stapler gun is suitable for the following purposes:
- Attaching coverings to the seating surface of
chairs.
- Attaching a skirting at the joint between wall
and floor coverings.
- Stretching and stapling canvasses to frames.
- Attaching protective films to insulation materials
when installing thermal insulation.
- Attaching decorative materials.
Q
removingstaples
m Toavoidtheriskofinjury!
j Ensure that the operating handle 1 will not be
pressed
j Push the hook 3 under the staple or nail head
(see Fig. F).
j Pull the rear part of the stapler gun upwards to
draw out the staple or nail from the workpiece.
Q
removingjammedstaples
fromthestaplergun
Staples or nails may become jammed in the stapler
gun during operation. Remove jammed staples as
follows:
1. Press in the staple pusher
2 slightly and then
pull it downwards. Then pull the staple pusher 2
completely out of the magazine 4 .
2. Turn the stapler gun over so that the magazine
4 is pointing upwards.
3. Press the magazine 4 at the side wings 5
backwards and pull the magazine 4 upwards
(see Fig. E).
4. Now remove the jammed staples from the
magazine 4 .
5. Press the magazine 4 at the side wings 5
backwards and press it downwards until it en-
gages to fix the magazine
4 back in place.
Note: Do not use the stapler gun if it shows more
serious defects (damage to body etc.). If necessary
have your stapler repaired by a qualified specialist.
Take note that the manufacturer’s original spare
parts only should be used in any repair.
Q
Tips
1. In order to have a good quality of stapling, it is
suggested to fill only one of staple / nail type in
the staple gun in each time.
2. When you want to change other types of sta-
ples, please make sure all remaining staples /
nails are used up or not in staple gun before
insert other types of staples/nails.
Q Cleaningandcare
j The product must be kept clean, dry and free
of oil or lubricants at all times.
j Clean the product with a slightly dampened,
non-fluffing cloth.
j Never use corrosive or abrasive cleaning
agents. These may damage the surface of the
product.
Q Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
53466_Handtacker_Content_LB4.indd 7 17.05.10 15:18