Epson COLOR Copy Station 8600 User Manual
Page 21
Advertising
Setting Up the Printer
21
E
ngl
is
h
1. Unpack the printer as explained in the printer’s Unpacking
Sheet, then follow the instructions in the printer’s Setup Guide
to carry out the following procedures.
❏
Installing the face-up tray
❏
Installing the toner cartridges
❏
Installing the photoconductor unit
2. Make sure that the printer is not plugged in.
3. Remove the two screws securing the shield plate on the rear
of the printer; then remove the plate.
Note:
❏
You will need the screws to secure the printer interface board
later in this procedure.
❏
Keep the shield plate in a safe place. You will need to reattach it
if you remove the interface board later.
Advertising