Monitoring 5.1 channel sound – Edirol UA-1000 User Manual
Page 31
31
Basic connections and settings
Monitoring 5.1 channel sound
fig.51ch
●
Connections
Connect phone jack audio cables to the output jacks.
●
Output volume select switch
Press the
output volume select switch
to select ALL (lit).
●
Output volume knob
Use the knob to adjust the volume level of signal that is output from the output jacks.
●
UA-1000 internal patching
Set patch bay as follows in UA-1000 Control Panel.
* For details on UA-1000 Control Panel, refer to
In the
PATCH BAY
area of UA-1000 Control Panel set
OUTPUT 1-2
to
WAVE OUT 1-2
,
OUTPUT 3-4
to
WAVE OUT 3-4
,
OUTPUT 5-6
to
WAVE OUT 5-6
.
5.1ch speaker
system
ALL
Settings in Windows
1. From the Windows Control Panel, open Sound and Audio Devices Properties.
(-> “Input/output device settings” (p. 24))
2. Click the Audio tab.
In Sound Playback, click the Default Device field, and choose EDIROL UA-1000 from the list that
appears.
3. In Sound Playback, click [Advanced].
4. Click the Speakers tab.
Select 5.1 surround sound speakers as Speaker setup.
5. Click [OK] to close the Advanced Audio Properties dialog box.
6. Click [OK] to close the Sounds and Audio Devices Properties dialog box.
*
In your software, select 6-speaker mode, 5.1 ch surround sound mode, etc.
UA-1000_e.book 31 ページ ２００３年８月６日 水曜日 午前１１時５２分