Introduction to shortwave – Eton G1000A User Manual

Page 13

Advertising
background image

13

G1000A

OPERATION MANUAL

INTRODUCTION TO SHORTWAVE

continued

BAND

MEGAHERTZ (MHz)

KILOHERTZ (KHz)

G1000A’S

(as on the G1000A) (as in most broadcast)

switch setting

49 meters

5.950-6.20 MHz

5950- 6200 KHz

SW1

41 meters

7.10-7.60 MHz

7100- 7600 KHz

SW2

31 meters

9.20-9.90 MHz

9500- 9900 KHz

SW3

25 meters

11.600-12.200 MHz

11600-12100 KHz

SW4

22 meters

13.570-13.870 MHz

13570-13870 KHz

SW5

19 meters

15.10-15.80 MHz

15100-15800 KHz

SW6

16 meters

17.480-17.90 MHz

17480-17900 KHz

SW7

13 meters

21.450-21.850 MHz

21450-21850 KHz

SW8

DAY BANDS / NIGHT BANDS – THE DIFFERENCE
IS VERY IMPORTANT
Because shortwave signals depend on such factors as the sun, the
ionosphere and interaction with the earth itself, signals cannot be
heard on all bands throughout the day. Some bands are best during
the daylight hours, and some are best at night. Here are some good
‘rules of thumb’.
• In general, the bands with frequencies below 13000 KHz are better

at night and the bands with frequencies above 13000 KHz are best
during the day. This guideline is not ‘cast in concrete’ but is a useful
general rule of thumb.

• Around sunrise and sunset, both the day and night bands might

be good, sometimes exceptionally good.

• In the summer time, the day bands often are good into the

early night.

• While most shortwave stations are found within the frequency

limits of these defined bands, some are found outside of them.
It pays to take the time to tune in-between bands too.

• These guidelines can be used worldwide and are not dependent

on location.

Advertising