Medal Sports SH1458115 User Manual

Page 15

Advertising
background image

ON / OFF

ENCENDIDO / APAGADO

VISITOR / VISITANTE

ELECTRONIC SCORER OPERATION

OPERACIÓN DEL MARCADOR ELECTRÓNICO

www.themdsports.com

1458115

14

(La ultima página)

(The last page)

Español

English

WARNING:

!

1) Requires 3 “AA” batteries (not included).

2) Do not mix old and new batteries.

3) Do not mix alkaline, standard (carbon zinc), or

rechargeable (nickel-cadmium) batteries.

ADVERTENCIA:

!

1) Requiere 3 “AA” baterias (no incluido).

2) No mezcles baterias viejas y nuevas.

3) No mezcles baterias alkalina, estándar (carbón,

cinc), o recargable (níquel-cadmio).

Install Batteries

Battery Box: Unscrew bolt using a screwdriver and open the

battery box. Insert 3 “AA” batteries ( not included) in the order of

polarity as shown on the inside cover. Then close the cover using

a screwdriver. Turn the power ON using the ON/OFF switch.

Reminding:

a. Batteries must be installed according to the correct polarization

(+ and -) requires.

b. Please clean the battery contacts and also those of the devices prior to

battery installation.

c. If the game will not be used for a long period of time, we recommend

that the batteries should be removed.

How to play?

1. While game is in Sleep Mode, if a basketball is scored, the game will

turn back on and the score board will begin the 5 sec. countdown.

2. After finishing the game, Turn OFF the scorer by using the ON/OFF

switch. NOTE: The scoreboard will turn off after 5 minutes, if not in use,

however, we recommend turning the ON/OFF switch to OFF when the

game will not be used for an extended period of time.

Instalación de las pilas

Caja de Batería:Desatornille el cerrojo por usando un

destornillador y abra la Caja de Batería, inserte 3 “AA” baterias

(no incluido) al orden de polaridad como mostrado el interno de

la Caja de Batería. Y luegp atornille sobre

la

cubierta usando un

destornillador.

Atención:

a.

Las pilas deben ser instaladas según la polarización correcta

requerido (+ y -).

b. Limpie los contactos de baterias y también los aparatos antes de la

instalación de batería.

c. Si no jugará el juego por un largo período de tiempo, recomendamos

que quite las baterias.

¿Cómo jugar?

1. Cuando el juego está en Modo de Dormir, si un baloncesto ha marcado

el puntaje, se vuelve al juego y el marcador de puntos iniciará ua cuenta

regresiva de 5 segundos.

2. Después de finalizar el juego, Apague el marcador de puntos usando el

interruptor de PRENDER/APAGAR (ON/OFF). Nota: el marcador de

puntos se apagará después de 5 minutos al no ser usado, sin embargo,

le recomendamos apagar el interruptor PRENDER/APAGAR (ON/OFF)

en APAGAR (OFF) cuando el juego no sería continuado por un

periódo prolongado.

NOTA: Este equipo ha sido probado y encontrado para cumplir

con los límites para el dispositivo digital de Clase B, de

conformidad con la Parte 15 de las Reglas de FCC. Estos límites

son diseñados para proporcionar protección razonable contra la

interferencia dañosa en una instalación residencial. Este equipo

genera, usa y podría irradiar la energía de radiofrecuencia y, si

no fuera instalado y usado conforme con las instrucciones,

podría causar interferencia dañosa para la comunicación de

radio. Sin embargo, no está garantizado que la interferencia no

ocurrirá en una instalación particular. Si este equipo realmente

causado interferencia dañosa a la radio o la recepción de

televisión, podría ser determinada por girando el equipo off y on,

el usuario está animado de corregir la interferencia por una o

más siguientes medidas:

-- Reoriente o recoloque la antena de recepción.

-- Incremente la separación entre el equipo y el receptor.

-- Conecte el equipo a una salida del circuito diferente que el que

está conectado con el receptor.

-- Consulte el proveedor o un técnico experienciado de radio/

televisión por ayudas

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of

the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

14

YOU ARE NOW READY TO PLAY!

¡VOUS ETES MAINTENANT PRET A JOUER!

Advertising