Meliconi Control 2 digital CME - Manual (Page 3)

8
NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it means the
system has not been able to process the data you have sent. Do not try sending another SMS use the MANUAL
SEARCH instead.
SETTING CODES USING A MANUAL SEARCH
(only to be performed if the specifi c code could not be found)
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code
found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN
USE procedure and make a note of it inside the battery cover.
1. Switch on the device to be programmed and select a pro-
gramme:
2. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
3. Release the button. The indicator light will fl ash. Point the
remote control at the device and press the ON/OFF but-
ton. If the device does NOT switch off, press the same
button again slowly (it may be necessary to press the
button several times).
4. When the device responds correctly, press OK. Three
long fl ashes indicate that the operation has been carried
out correctly.
6 SEC. or
Point the CME remote control at the device, which should already be ON and press the ON/OFF button on the remote.
If the device does NOT switch off, try setting the consecutive code in the SMS list on the remote control.
When the device reacts check whether the other buttons are operating correctly too.
If they do, the remote control is ready to use.
If they don’t, you are probably using an incorrect code destined for a very similar device; at this point ignore the
SMS list and consult the SETTING CODES USING A MANUAL SEARCH section to fi nd a more suitable code.