Meliconi Control 2 digital CME - Manual (Page 4)

9
DISPLAY CODE IN USE
If you set up the remote control using the MANUAL SEARCH
procedure, obtain and make a note of the code in use as follows:
1. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
2. Release the button. The indicator light will fl ash. Press
the TV / radio button for an instant.
3. After a pause of several seconds, the indicator light pro-
duces four sets of fl ashes, spaced out, corresponding to
the code to be obtained. Count the number of fl ashes.
Each set of fl ashes corresponds to one fi gure in the
code. Ten fl ashes correspond to the fi gure 0.
4. Make a note of the code obtained on the label on the in-
side of the battery cover. You may need it in future.
Code obtained = 1306
6 SEC. or
ENTERING THE CODE DIRECTLY
(only to be performed if you know the specifi c code to be set)
If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated
is not included in the remote control.
1. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
2. Release the button. The indicator light fl ashes.
Immediately enter the specifi c code previously found.
(e.g. 1306).
3. Three long fl ashes indicate a correct setting.
6 SEC. or
NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode in the
following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to fi nd is terminated. In this case, visit the www.cme.it website.