RISCO Group WL Supervised Smoke User Manual
Page 55
55
RTTE Compliance Statement
Hereby, RISCO Group declares that this equipment is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. For the CE Declaration
of Conformity please refer to our website: www.riscogroup.com.
UL Compliance Section
This product is UL639 listed for Residential and Commercial intrusion detectors.
To comply with UL, note the following:
♦ The units are intended to be connected to a Listed control unit or Burglar alarm
power supply with output voltage range between 9-16vdc that provides a
minimum of four hours standby.
♦ The unit relays are to be connected to resistive loads only .
♦ For indoor use only.
CE CPR Approval
The wireless smoke and heat detector, RWT33S86800B, designed by RISCO Ltd in Israel,
assembled in China, has been tested and approved according to the CPR directive
305/2001/EU, standard EN 14604:2005/AC:2008 by ANPI, BELGIUM number
1134-CPR-109
FCC Note (for 433.92 MHz)
FCC ID: JE4RWT30S433
IC: 6564A-RWT30S
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance, RISCO Group could void the user's authority to operate the
equipment.
* 433.92 MHz: RWT33S43300A