Important safeguards, Warning save these instructions, General information – Eureka 420 Series User Manual

Page 2: Service information, Automatic motor shut-off

Advertising
background image

DO NOT OIL the motors or brushroll. The

motors and brushroll are permanently sealed

and lubricated.

To reduce the risk of fire, electric shock, or injury :
Do not use outdoors or on wet surfaces.

Do not leave vacuum cleaner when plugged in. Turn off

the switch and unplug the electrical cord when not in use

and before servicing.

Do not allow to be used as a toy. Close attention is

necessary when used by or near children.

Use only as described in this manual. Use only

manufacturerʼs recommended attachments.

Do not use with damaged cord or plug. If vacuum cleaner

is not working as it should, has been dropped, damaged,

left outdoors, or dropped into water, return it to a service

center before using.

Do not pull or carry by cord, use cord as a handle, close

door on cord, or pull cord around sharp edges or corners.

Do not run vacuum cleaner over cord. Keep cord away

from heated surfaces.

Do not use extension cords or outlets with inadequate

current carrying capacity.

2

Turn off all controls before unplugging.

Do not unplug by pulling on cord. To unplug, grasp the

plug, not the cord.

Do not handle plug or vacuum cleaner with wet hands or

operate without shoes.

Do not put any object into openings. Do not use with any

opening blocked; keep free of dust, lint, hair, and anything

that may reduce airflow.

This vacuum cleaner creates suction and contains a

revolving brushroll. Keep hair, loose clothing, fingers, and

all parts of body away from openings and moving parts.

Do not pick up anything that is burning or smoking, such

as cigarettes, matches, or hot ashes.

Do not use without dust cup or filter in place.

Use extra care when cleaning on stairs.

Do not use to pick up flammable or combustible liquids such

as gasoline, or use in areas where they may be present.

Store your cleaner indoors in a cool, dry area.

Keep your work area well lighted.

Unplug electrical appliances before vacuuming them.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.

WARNING

SAVE THESE INSTRUCTIONS

To reduce the risk of electric shock, this appliance has a

polarized plug (one blade is wider than the other). This plug

will fit in a polarized outlet only one way. If the plug does not

fit fully into the outlet, reverse the plug. If it still does not fit,

contact a qualified electrician to install the proper outlet. Do

not change the plug in any way.

GENERAL INFORMATION

Use the cleaner to pick up dirt and dust particles. Avoid

picking up hard or sharp objects that could damage the

vacuum cleaner.

Service Information

The instructions in this booklet serve as a guide to routine

maintenance. For additional service information, telephone

our toll free number for the nearest Eureka Authorized

Warranty Station. You should know the model, type and

serial number or date code when you call :

USA : 1-800-282-2886 Mexico : 5670-6169

Canada : 1-800-282-2886

If you prefer, you can write to Electrolux Home Care Products

North America, Consumer Service, P. O. Box 3900, Peoria,

Illinois, 61612, USA. In Canada, write to Electrolux Home

Care Products Canada, 866 Langs Drive, Cambridge, Ontario

N3H 2N7. Refer to The Eureka Warranty for complete service

information.

Automatic Motor Shut-Off

To protect from overheating, this vacuum cleaner is

equipped with a thermostat which automatically shuts off

the suction motor if it overheats. Should this happen:
1. Turn off the switch and unplug the cleaner because

the thermostat will allow the cleaner to automatically

start running again when the motor cools (approximately

30 minutes).

2. Check the dust cup and filter regularly, as a full dust

cup or dirty filter could cause the motor to overheat.

3. Call a Eureka Authorized Warranty Station if the

cleaner will not operate after cooling for approximately

30 minutes.

Advertising