Epson PC3000Z - Manual (Page 17)

4. Open the connector cover on the side of the camera.
5. Depending on the type of cable you have, line up
either the arrow or the flat surface of the long cable
connector with the mark on the camera’s serial port.
Then insert the connector.
6. Turn on the camera and your computer system.
c
Caution:
o If you connected the camera to a serial port that
you use for another device and AppleTalk is
turned on, turn off AppleTalk. The computer may
not recognize the camera if AppleTalk is turned on.
o Keep the entire computer system away from
potential sources of electromagnetic interference,
such as loudspeakers or the base units of cordless
telephones.
Accessing EPSON Photo!2
Once your camera and computer are connected and
turned on, you are ready to start working with the
EPSON Photo!2 software that came with your camera.
This software allows you to download your photos to
your computer so you can use them in your documents.
If you have not installed EPSON Photo!2 yet, do so now,
following the instructions in Chapter 1. Then follow the
instructions in this section to access the software.
connector cover
mark
flat surface
arrow surface
or
L EPSON Photo!2 Rev.C
A5 size Chapter 2
5/8/98 pass 0
2-4 Using EPSON Photo!2