KEPCO HSM Series User Manual
Kepco, Operator’s manual, Hsm series
Advertising
Table of contents
Document Outline
- SECTION I - INTRODUCTION
- 1.1 Scope of Manual
- 1.2 General Description
- 1.3 Specifications
- 1.4 Miscellaneous Features
- 1.4.1 Control/programming
- 1.4.2 Status Flags:
- 1.4.3 Setpoint Monitors:
- 1.4.4 Remote Error Sensing:
- 1.4.5 Load Sharing:
- 1.4.6 Load Monitor:
- 1.4.7 Auxiliary Supply:
- 1.4.8 Overcurrent/undervoltage Protection:
- 1.4.9 Current Walk-in:
- 1.4.10 Remote Reset:
- 1.5 Options
- 1.5.1 Battery Charger (B Suffix):
- 1.6 Accessories
- SECTION 2 - INSTALLATION
- 2.1 Unpacking and Inspection
- 2.2 Terminations and Controls
- 2.3 Source Power Requirements
- 2.4 Cooling
- 2.5 Preliminary Operational Check
- 2.6 Installation
- 2.7 Wiring Instructions
- 2.7.1 Safety Grounding
- 2.7.2 Source Power Connections
- 2.7.3 D-C Output Grounding
- 2.7.4 Power Supply/Load Interface
- 2.7.5 Load Connection - General
- 2.7.5.1 Load Connection - Method I (Local Error Sensing)
- 2.7.5.2 Load Connection - Method II (Remote Error Sensing)
- 2.7.5.3 Load Connection - Method III (Series Connection)
- 2.7.5.4 Load Connection - Method IV (Parallel/Redundant Operation)
- 2.7.6 Load Sharing
- 2.7.7 Signal Connections
- SECTION 3 - OPERATING INSTRUCTIONS
- 3.1 Operating Configuration
- 3.2 Remote Error Sense
- 3.3 Output Voltage Programming
- 3.4 Output Voltage Range
- 3.5 Current Limit Programming
- 3.6 Current Limit Programming Range
- 3.7 Setpoint Monitors
- 3.8 Overvoltage Protection Adjustment
- 3.9 Current Limit Characteristic
- 3.10 Current Walk-in Circuit
- 3.11 5VAUX Floating Supply
- 3.12 Remote Inhibit/Remote Reset Controls
- 3.13 Module Current Monitor
- 3.14 Status Flags
- 3.14.1 Source Power Status Flags
- 3.14.2 OUTPUT Status Flags
- 3.14.3 OVERTEMP Status Flags
- 3.14.4 FANFAIL Status Flags