KEPCO RA 19-4B - Manual (Page 34)

2-24
RA 19-4B 011409
2.9 INSTALLING/REMOVING HSF POWER SUPPLIES
Removal of an HSF power supply from a “live” system must be done only by
authorized service personnel after HSF power switch is set to OFF. Danger-
ous voltages may be accessible through the open slot after a power supply
is removed.
Refer to Figure 1-1, for proper slot positions applicable to the RA 19-4B Rack Adapter. Insert
HSF power supply in selected slot until power supply front panel is flush with rack adapter chas-
sis and secure with two phillips screws on power supply.
2.10 SHIPPING
The rack adapter may be shipped with power supplies installed only after the HSF power sup-
plies have been securely fastened to the rack adapter (PAR. 2.9). Contact Kepco Applications
Engineering if further assistance is required.
WARNING