Mounting instructions – SAF-HOLLAND XL-PH10412UM PH-995 Pin and Clevis Coupler User Manual
Page 10
10
XL-PH10412UM-en-US Rev A · 2011-10-28 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Mounting Instructions
Figure 8
Figure 9
Figure 10
Figure 11
6. PH-995SN71 Installation
(Retrofit of PH-775-01552)
Before installation make sure that the
mounting structure is of sufficient strength
to support the rated capacities of the
coupler. Refer to SAE J847 for structural
performance requirements.
3FNPWBMPGUIF1)DPVQMFS
1. Remove the cotter pin (XB-781-1) from
the castellated nut (XB-780-1) (Figure 8).
Discard the used cotter pin.
2. While holding and supporting the pintle
hook body remove the castellated nut
(XB-780-1) (Figure 9). Discard the
used castellated nut.
3. While holding and supporting the pintle
hook body remove the washer (XA-782)
(Figure 10). Discard the used washer.
4. Remove the pintle hook body from
the housing (XA-749 or XA-749-1) by
pulling it straight out of the housing
(Figure 11). Set aside the used pintle
hook body.
NOTE: Use new installation hardware
with supplied PH-995SN71.
TOP VIEW
$055&3
1*/
$"45&--"5&%/65
8"4)&3
1*/5-&)00,#0%:
)064*/(
$"45&--"5&%/65