EnGenius Technologies ESR-9710 - Manual (Page 2)

Quick Start Guide Wireless N Gigabit Router
Quick Start Guide v.1.0 ESR-9710 Wireless N Gigabit Router 2
network that support Wi-Fi Protected Setup.
Hardware Installation
1. Place the unit in an appropriate place after conducting a site survey.
2. Plug one end of the Ethernet cable into the LAN port of the device and another end into your
PC/Notebook.
3. Plug one end of another Ethernet cable to WAN port of the device and the other end into you
cable/DSL modem (Internet)
4. Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the other end into the
power socket on the wall.
IP Address Configuration
The default IP address of the device is 192.168.1.2 In order to log into this device, you must first
configure the TCP/IP settings of your PC/Notebook.
1. In the control panel, double click Network
Connections and then double click on the
connection of your Network Interface Card (NIC).
You will then see the following screen.
2. Select Internet Protocol (TCP/IP) and then click
on the Properties button. This will allow you to
configure the TCP/IP settings of your
PC/Notebook.
3. Select Use the following IP Address radio
button and then enter the IP address
(192.168.1.21) and subnet mask (255.255.255.0). Ensure that the IP address and subnet mask are
on the same subnet as the device.
4. Click on the OK button to close this window, and once again to close LAN properties window.
Logging In
1. To configure the device through the web-browser, enter the IP address of the device (default:
192.168.1.2) into the address bar of the web-browser and press Enter.
2. After connecting to the IP address, the web-browser will display the login page. Select Admin from
the drop-down list and then leave the password field blank. Click on the Log In button to continue.