EnGenius Technologies ESR-9710 - Manual (Page 4)

Quick Start Guide Wireless N Gigabit Router
Quick Start Guide v.1.0 ESR-9710 Wireless N Gigabit Router 4
L2TP
1. Select the L2TP radio button and then click on the Next button.
2. Address Mode: L2TP can be used with a dynamic or static IP address. If you select the Dynamic
IP radio button, then the IIP address in the next field is not required. However, if you select the
Static IP radio button, then the IP address in the next field is required.
3. PPTP Address: Specify the IP address
4. PPTP Subnet Mask: Specify the subnet mask for the IP address.
5. PPTP Gateway IP Address: Specify the IP address of the PPTP gateway.
6. PPTP Server IP Address: If the PPTP Server’s IP address is different from the default gateway,
then you may specify it here.
7. User Name: Specify the user name which is provided by your ISP.
8. Password: Specify the password which is provided by your ISP, and then verify it once again in
the next field.
9. Click on the Next button to continue.
10. The WAN configuration is complete. Click on the Connect button to connect to the Internet.
Static IP Address
1. Select the Static IP Address Connection radio button and then click on the Next button.
2. IP Address: Specify the IP address for this device, which is assigned by your ISP.
3. Subnet Mask: Specify the subnet mask for this IP address, which is assigned by your ISP.
4. Gateway Address: Specify the IP address of the default gateway, which is assigned by your ISP.
5. Primary/Secondary DNS Address: Specify the primary and secondary IP address, which is
assigned by your ISP.
6. Click on the Next button to continue.
7. The WAN configuration is complete. Click on the Connect button to connect to the Internet.
Static IP Address
1. Select the BigPond radio button and then click on the Next button.
2. User Name: Specify the user name which is provided by your ISP.
3. Password: Specify the password which is provided by your ISP, and then verify it once again in the
next field.
4. BingPond Server: Specify the server name or IP address as specified by your ISP.
5. Click on the Next button to continue.
6. The WAN configuration is complete. Click on the Connect button to connect to the Internet.
Wireless Network Setup
1. Click on the Wizard_Wireless link under the Basic menu, and then click on the Wireless Network
Setup Wizard button. The wizard will inform you that there are two options: auto and manual.
Automatic Network Setup