Electrolux 241940002 - Manual (Page 35)

35 Solutions to Common Problems
Temperatures Are Too Cold
Problem Cause Correction
Freezer temperature
too cold. Refrigerator
temperature is
satisfactory.
Freezer control is set too cold. •
Ice maker is on. •
Set freezer control to a warmer setting. Allow 24 hours •
for temperature to stabilize.
It is normal for the freezer compartment to over cool •
while automatic ice maker is on.
Refrigerator temperature
too cold. Freezer
temperature is
satisfactory.
Refrigerator control is set too cold. • Set refrigerator control to a warmer setting. Allow 24 •
hours for temperature to stabilize.
Food stored in drawers
freezes.
Refrigerator control is set too cold. • See solution above. •
Food stored in Meat
Keeper freezes (select
models).
Meat Keeper temperature control is set too •
cold.
Adjust Meat Keeper temperature control to a warmer •
setting. Meat should be stored at a temperature just
below the freezing point for maximum fresh storage
time. It is normal for ice crystals to form due to the
moisture content of meat.
Running Your Refrigerator (continued)
Problem Cause Correction
Refrigerator runs too
much or too long.
Room or outside weather is hot. •
Refrigerator has recently been disconnected •
for a period of time.
Automatic ice maker is operating. •
Doors are opened too frequently or too long. •
Refrigerator/freezer door may be slightly •
open.
Freezer control is set too cold (control found •
in fresh food section).
Fresh food/freezer gasket is dirty, worn, •
cracked, or poorly fitted.
This model is provided with a high-efficiency, •
variable-speed compressor.
It’s normal for the refrigerator to work longer under •
these conditions.
It takes 8-12 hours for the refrigerator to cool down •
completely.
Ice maker operation causes refrigerator to run slightly •
more.
Warm air entering the refrigerator causes it to run more. •
Open doors less often.
Ensure refrigerator is level. Keep food and containers •
from blocking door. See Problem section, Opening/
Closing of Doors/ Drawers.
Set freezer control to warmer setting until refrigerator •
temperature is satisfactory. Allow 24 hours for
temperature to stabilize.
Clean or change gasket. Leaks in door seal will cause •
refrigerator to run longer in order to maintain desired
temperatures.
It is normal for the compressor to run for long periods •
of time.
Digital temperature
displays are flashing.
Electronic control system has detected a •
performance problem.
Call your Electrolux service representative, who can •
interpret any messages or number codes flashing on
the digital displays.
Temperatures Are Too Warm
Problem Cause Correction
Freezer/Refrigerator
temperature is too warm.
Doors are opened too frequently or too long. •
Door is slightly open. •
Warm air enters the refrigerator whenever the door is •
opened. Open the door less often.
See Problem section, Opening/Closing of Doors/ •
Drawers.
Freezer temperature is
too warm. Refrigerator
temperature is
satisfactory.
Freezer control is set too warm. • Set freezer control to a colder setting. Allow 24 hours •
for temperature to stabilize.