Controlling the v-44sw from a pr-80/50 – Edirol V-44SW E1 User Manual
Page 47
47
Using the V-44SW with Other Devices
■
Controlling the V-44SW from a PR-80/50
You can control the V-44SW remotely from an Edirol PR-80 or
PR-50 (hereafter referred to as PR Series devices) via MIDI.
The following operations can be controlled from the PR Series
device.
●
You can use the PR Series Scheduler function for
automatic operation of the V-44SW.
●
You can use the PR Series Scheduler for automatic
operation of the V-44SW.
●
Connect the video output from the PR Series device to one of the
SD S-VIDEO connectors 1–4 or SD COMPOSITE connectors 1–
4.
●
For instructions on setting and operation of the PR series device,
refer to the PR Series device Owner’s Manual.
■
Transmitting Settings to Another
V-44SW (Bulk Dump)
You can transmit one V-44SW’s parameter settings to another
V-44SW as MIDI data
Connect the MIDI OUT/THRU connector of the V-44SW
transmitting the settings to the MIDI IN connector of the
V-44SW receiving the settings.
About the Receiving V-44SW
●
When MIDI data is received, the settings on the receiving device
are overwritten, and the previous settings are lost. If you want to
save your settings, back up the V-44SW’s settings to a computer.
☞
“Backing Up the V-44SW’s Settings to a Computer” (p. 49).
●
When using the V-44SW while linked with the V-440HD, the
settings of the V-440HD can be transmitted to the V-44SW. In this
case, the V-44SW’s operational mode needs to be switched to
“V-440HD Slave Mode” (p. 44).
If MIDI data is received from the V-440HD without switching the
operational mode, the panel preset functionality (p. 42) of the
V-44SW may fail to operate properly.
●
Before beginning the bulk dump, be sure the Device ID setting is
the same for both the transmitting and receiving device.
Set the Device ID with “6: Device ID” under “9. MIDI Setup” in the
menu.
1
Press the [MENU] button to display the Main menu.
2
Select “9. MIDI Setup” and then select “18: MIDI Bulk
Dump” from the sub-menu.
3
Select “Yes.”
4
Press the [ENTER] button.
The MIDI data is transmitted from the transmitting V-44SW.
Connection Example
Use a PR Series device running ver. 1.2 or later.
Composite or S-Video
MIDI
IN
USB MIDI Interface
(UM-1EX etc.)
V-44SW Rear Panel
PR-80/50
RGB Video
SD Video
HD Video
Making the Connections
Procedure
MIDI OUT/THRU
MIDI IN
Transmitting V-44SW
Receiving V-44SW
V-44SW Rear Panel
V-44SW Rear Panel
V-44SW_e.book 47 ページ ２００６年１０月２３日 月曜日 午後３時２５分