DE DIETRICH DLZ491JE1 - Manual (Page 71)

2.- Clean the COMPARTMENTS of the
DRAWER using a brush and warm
water.
3.- Clean the siphons of the liquid com-
partments also.
After this is done, put the drawer back into
the washing machine.
Troubleshooting guide
Should anything go wrong with the functio-
ning of the washing machine, you can pro-
bably put it right by referring to the follo-
wing advice.
However, should the problem persist,
unplug the washing machine and contact
our TECHNICAL ASSISTANCE SERVICE.
There are no fuses or analogue compo-
nents which can be changed by the user.
But we urge you that under no circumstan-
ces should you attempt to open up the
machine.
The washing machine won’t start
– There is no electricity
– The washing machine is not plugged in
at the mains.
– The fuses on the fuse board have
blown.
– The loading door has not been closed
correctly.
– The Start button has not been pushed
in.
The washing machine does not take in
water
– The water has been cut off.
– he water inlet tap has not been turned
on.
– The hose filter is blocked.
– The water inlet pipe is tangled.
The washing machine will neither
release the water nor spin dry
– The water drain pipe is tangled.
The washing machine vibrates or makes
excessive noise
– The INTERIOR FASTENING SCREWS
have not been taken out.
– The washing machine is not on a level
surface.
(Consult the Installation
manual).
Important:
All models have a safety device incorpora-
ted into their spin dry programmes which
means that the programme will stop should
the garments inside the drum concentrate
in such a way as to create an excessive
level of vibrations. Should you ever find that
the garments are not sufficiently wrung out,
try spin drying them once more after you
have distributed them more evenly inside
the drum.
Drying instructions
The drying system
The drying process occurs due to hot air
circulating in a closed circuit and steam
condensing by means of refrigeration with
mains water.
Therefore IT IS ABSOLUTELY IMPERATIVE
FOR THE MAINS WATER TAP TO BE TUR-
NED ON DURING THE DRYING CYCLES
ALSO.
The water drainage pump will simultane-
ously switch on at regular intervals during
the whole drying programme in order to
release the refrigeration water in addition
to the water coming from the condensation.
During the last few minutes of the drying
cycle, there is no heating up of circulating
air. This is in order to even out the tempe-
ratures inside the drum so that no creases
should form. You are strongly recommen-
ded NOT TO INTERRUPT THIS FINAL
STAGE.
Preparing the garments
Check the manufacturer’s instructions on
all garment labels and make sure that they
can be machine dried. Do not machine dry
any excessively delicate items such as cur-
71
ENGLISH