DE DIETRICH DVC829WE1/XE1 - Manual (Page 10)

40
5/ DETERGENT PRODUCTS AND SETTING THE WATER SOFTENER EN
• FOR TRADITIONAL PRODUCTS
• FOR MULTI-PURPOSE PRODUCTS
• Your appliance can be specially set to use multi-purpose if the water hard-
ness is < 25°F.
Advice :
For better coverage of the variety of multi-purpose products available, your dishwasher’s
option has two possible settings
• Proceed to set the option, if necessary
— Refer to the table below ( light permanently lit or flashing).
“Extra Dry” (factory setting) improves drying results in the event of lower performance from the type
“2-in-1”, “3-in-1” or “4-in-1” multi-purpose product.
“Sparkling Clean” prioritises the brilliance of your items, whatever the type of multi-purpose pro-
duct used.
Light unlit: Light permanently lit : light flashing :
S So offtte en ne err s se ettttiin ng g
T Te es sttiin ng g s sttrriip p H Ha arrd dn ne es ss s T Trra ad diittiio on na all p prro od du uc ctts s M Mu ullttii--p pu urrp po os se e p prro od du uc ctts s
0 - 10°F
10 - 25°F
25 - 40°F
40 - 55°F
55 - 70°F
> 70°F
““S Sp pa arrk klliin ng g
C Clle ea an n””
““E Ex xttrra a D Drry y””
((ffa ac ctto orry y
s se ettttiin ng g))
““E Ex xttrra a D Drry y””
((ffa ac ctto orry y
s se ettttiin ng g))
““S Sp pa arrk klliin ng g
C Clle ea an n””
• Proceed as follows to adjust the water
softener on the control panel:
— Access setting mode by holding down the “Set ” but-
ton until you hear a double audible signal (long beep);
the indicator lights illuminate (Fig. 02).
— Press one button or the other once
; the
lights that are lit indicate the setting (factory setting 40 - 55°F).
— Briefly press one button or the other
in succession to adjust the setting to suit the water
hardness.
— The setting is validated automatically after 10 seconds if the
“Set” button in not pressed again.
— Refer to the table below
• Your appliance must be specially set to use traditional products.
Fig.02