DE DIETRICH DVC829WE1/XE1 - Manual (Page 25)

55
13/ IF OPERATING ANOMALIES OCCUR EN
Problem Possible C auses What to do ?
The appliance will not restart - Door opened during a wash-
ing cycle.
- Wait for the time delay for
resuming the cycle to end
(controlled internally by the
appliance).
The appliance does not drain
(Cf. table fault d02). - The cover has not been
removed from the sink’s U-
bend.
- Drain hose kinked.
- Filters totally blocked.
- Pump blocked.
- Remove the cover.
- Check the drain hose line
behind the machine is OK.
- Remove and clean the filters
and the drain.
- Initiate a Soaking programme
If the fault persists, call a tech-
nician.
• POOR WASHING RESULTS
Problem Possible C auses What to do ?
Food traces, deposits, “sand
grains” in the glasses - Items poorly arranged (mas-
ked by another larger item or
situated underneath it, items
nested or jammed together).
- Upper rotor blocked by cutlery
or a dish etc.
- Filter poorly locked and lifting
during washing.
- Micro filter screen clogged.
- One or more holes in the rotor
blocked.
- Arrange the items properly.
Use the most appropriate
areas and accessories for each
type of item (see instructions).
- Check that the rotor rotates
freely (gauge wire). Set the
basket in the high position if
necessary.
- Check the filter’s facing and that
the filter is locked in place (push
it in fully, turning it to the right).
- Remove all, the filters and
clean them (in warm water),
including the micro filter’s
screen (once a month).
- Remove the rotor by turning
the lever a quarter of a turn and
clean it under the tap (do not
use any tool that could damage
the holes). Re-install the rotor.
Traces of grease - Detergent dose too low; ineffi-
cient detergent ; stale product.
- Inappropriate programme
(temperature too low; duration
too short).
- Increase the dose ; try another
detergent.
- Select a programme with a
higher temperature.