Eclipse - Fujitsu Ten CD1000 - Manual (Page 10)

- 10 -
English
E
spañol
Français
Italiano
Nederlands
Svenska
English
6
5
4
Install the bezel on the main unit.
Fasten the rear of the main unit.
Insert the main unit into the mounting sleeve until
it locks in place.
Bezel 5 Bushing 9
Metal of vehicle
Stud bolt 8 Mount the stud bolt and bushing to the main unit. 3
• • Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
• • This installation method is only one example.
When installing the main unit to the vehicle, be
sure to ask the place of purchase for information
on the installation method used.
Tip
• •Carefully bind any excess length of wire that is connected to the main unit and secure it to an area of
empty space in the vehicle so that it does not dislodge or interfere with the main unit or vehicle-side
equipment. If the wires are not handled correctly, operating problems or short-circuits may occur, and
this may result in the danger of fire or other accidents.
• •Connect all wires before installing the main unit.
Tip
Insert the mounting sleeve into the opening in the
vehicle dashboard or console box. 1
Use a screwdriver or a similar tool to bend the
tabs in the mounting sleeve to secure the
mounting sleeve. 2
Bend the mounting
tabs.
Dashboard or
console box
Mounting sleeve 3
- Removing the main unit (If installing the main unit using the mounting sleeve) -
Mounting sleeve 3
Bezel 5
- Mounting the main unit (If installing the main unit using the mounting sleeve) -
Remove the detachable panel. 1
Remove the bezel. 2
3 Insert the audio unit removal tool on the left and
right side of main unit, and disengage the lock of
the mounting sleeve.
4 Remove the main unit from the mounting sleeve.
Dashboard or console box
Main unit 1
Main unit 1
Dashboard or
console box
Detachable panel
Detachable panel