Eureka BUILT-IN CV200 - Manual (Page 7)

7
HOW TO MAINTAIN
The instructions given in this booklet serve as a guide to routine maintenance. To
avoid unnecessary service calls check the belt and brush roll often. Replace the belt
if it is stretched or cracked and clean the brush roll bristles when they are wrapped
with thread and hair.
Brush Roll Belt and Headlight
The brush roll belt on the motorized nozzle drives the brush roll to agitate, sweep, and
comb the carpet nap. The belt should be checked regularly to be sure that it is in
good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any
hair or thread wound around the brush roll or belt pulleys because the buildup could
cause the belt to rotate unevenly.
How to Replace Worn Belt or Headlight Bulb
NOTE: Disconnect power cord and wands from electrical hose before
replacing belt or bulb. Belt pulleys can become hot during normal
use. To prevent burns, avoid touching the belt pulley when servicing
the drive belt.
1. Remove two screws from bottom
side. Turn over to grasp hood by
handle socket and lift forward.
Replace headlight bulb, if
necessary. Use GENUINE
EUREKA 25 watt replacement
bulb 40009A. Continue to step
2 to change belt. Skip to step 7
and 8 to replace hood on
motorized nozzle.
3. Lift out brush roll; replace new
belt around brush roll pulley.
5. Rotate belt onto motor pulley.
6. Replace brush roll cover.
7. Tilt cover over ridge and push down.
8. Secure with screws on underside
(refer to 1).
2. Remove two screws located in
front of the light bulb and lift up
to remove the brush roll cover.
4. Return brush roll into base.
Look for the symbol.
Use GENUINE EUREKA
replacement belt, 52201A.
GENUINE
EUREKA PRODUCT
Motor
Pulley
Ridge