Amprobe ACDC-400 Digital-Clamp-On-Multimeter User Manual
Page 11
10
battery Replacement (see fig. 9)
�
Warning
to prevent electrical shock or meter damage, disconnect the meter’s test leads from
any circuit and the meter, then turn the meter off before removing the battery
cover. battery replacement should be performed in a clean environment and with
appropriate care taken to avoid contaminating the meter’s interior components.
Remove the screw and lift the battery cover.
1.
Replace the batteries with the same type (1.5V AAA). note polarity guide below
2.
the battery.
Replace the battery cover and screw.
3.
SPECIfICAtIoNS
general Specifications
Display:
3-3/4 digits 4000 counts lCD display
Update Rate:
2 per second nominal
polarity:
Automatic
power Supply:
2 standard 1.5V AAA Size (neDA 24g or ieC
R03) battery
Battery life:
typical 25 hours
Apo Timing:
idle for 30 minutes
low battery:
�
on lCD; approx. 2.4V
environment:
indoor operation, below 2000 m
temperature / Humidity:
operating:
5°C to 40°C (41°f to 104 °f); < 80% Rh
Storage:
-10°C to 60°C (14°f to 122 °f); < 80% Rh
Jaw opening:
27mm max
Dimension :
202 x 70 x 40mm (7.9 x 2.7 x 1.6 in.)
weight :
254 gm (0.6 lb)
Safety lVD: Meets en60101-1:2001; en61010-2-032(2002), Category ii- 600 Volts ac
& dc; pollution degree : 2; class 2
�
eMC: This product complies with requirements of the following european
Community Directives: 89/336/eeC (electromagnetic Compatibility) and 73/23/eeC
(low Voltage) as amended by 93/68/eeC (Ce Marking). however, electrical noise
or intense electromagnetic fields in the vicinity of the equipment may disturb
the measurement circuit. Measuring instruments will also respond to unwanted