Amprobe MAN02 Manometers - Manual (Page 10)

6
E1oL or E2UL.
when you see these errors while operating computer software, it means pressure source is less
or over than the range of the instrument.
Replace your 9-volt battery when:
The • BAt icon appears on the right of the screen.
The meter will not power on. •
Use of the back-light causes the • BAt icon to appear.
Replacing the Battery
even if the battery was recently replaced, check its voltage level if you get no response from
your instrument.
To replace the battery:
Remove the tubing from the instrument. 1.
lay the instrument face-down on a clean, flat surface. 2.
Remove battery cover. 3.
Remove battery from instruments that you do not plan to use for a month or more.
do not leave battery in instrument.
USB PC INtERFACE CAPABILItIES
The USb cable and the download Suite software are required to transfer data to a pC. The USb
port is located on the right side of the instrument. The USb Cable is not included. it can be
purchased separately as an optional accessory.
Download Suite Software installation
insert the download Suite Cd into the Cd-RoM drive.
To install the software, follow the on-screen instructions.
operation
To open the program, double-click the download Suite icon.
To transfer data to a pC, follow the on-screen instructions.