Amprobe PY-11 Continuity Tester User Manual
Page 10
4
INTRODUCTION
The PY-11 continuity tester is designed to
be rugged and easy to use for the testing of
continuity in electrical circuit, fuses, sockets, door
bells, motors, switches, and other high wattage
appliances. It comes with a bulb light that
provides indication of continuity.
• Automatically turns ON and OFF for easy
and quick measurements
• Visual continuity indication (Light bulb)
OPERATION
Note: All function operations described hereafter
are via the stationary tip probe for positive (+)
polarity and the attached alligator clip probe for
Ground reference (-), or otherwise specified.
Automatic Operation
The tester automatically turns on when you
place the probes across a complete circuit. The
tester tests for continuity and the Light bulb
turns ON if there is a complete circuit.The tester
automatically turns off when you remove the
probes from the complete circuit.
Fuse Test (Refer to Fig.1)
Remove fuse from circuit, touch clip to one end of
fuse and probe to the other fuse end. Tester will
light if fuse is good. Do not use on fuses rated
300 mA or lower.
Continuity Testing
Light will glow whenever continuous circuit exists.