Amprobe PY-11 Continuity Tester User Manual
Page 12
6
MAINTENACE
Except for the replacement of the battery, repair
of the meter should be performed only by a
Factory Authorized Service Center or by other
qualified instrument service personnel. The
front panel and case can be cleaned with a mild
solution of detergent and water.Apply sparingly
with a soft cloth and allow to dry completely
before using. Do not use aromatic hydrocarbons,
Gasoline or chlorinated solvents for cleaning.
Battery Test and Replacement
Replace the batteries immediately if the
continuity Light doesn’t turn on when touching
both probes together. Follow the steps below:
1. Remove light bulb white cover cap
2. Remove the white wire together with the
light bulb
3. Remove the bad batteries and replace them
with 2 new AAA batteries.
4. Insert the light bulb with the attached
white wire and turn it counterclockwise.
5. Replace the white cap by pushing it down.