Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 11)

LSI Corporation
- 11 -
LSICVM02 Kit Quick Installation Guide
May 2014 Installing the LSICVM02 Kit
Installing the Remote Mount Board on the Motherboard
Installing the Remote Mount Board on the Motherboard
Follow these steps to install the remote mount board on the motherboard.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCIe slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Use the bracket screw to secure the remote mount board to the system chassis.
Figure 8 Installing the Remote Mount Board
5. Reinstall the computer cover, and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information about running the RAID configuration utility and
installing the software drivers.
3_01659-04
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
CacheVault
Flash Module 04
(CVFM04)
CacheVault
Power Module 02
(CVPM02)
Remote Mount
Board