Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 28)

LSI Corporation
- 28 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Drive Commands
storcli /cx[/ex]/sx start rebuild
This command starts a rebuild operation for a drive.
Input example:
storcli /c0/s4 start rebuild
storcli /cx[/ex]/sx stop rebuild
This command stops a rebuild operation. You can run this command only for a drive that is currently rebuilt.
Input example:
storcli /c0/s4 stop rebuild
4.3.11 Drive Copyback Commands
The Storage Command Line Tool supports the following commands for drive copyback:
storcli /cx[/ex]/sx pause copyback
storcli /cx[/ex]/sx resume copyback
storcli /cx[/ex]/sx show copyback
storcli /cx[/ex]/sx start copyback target=eid:sid
storcli /cx[/ex]/sx stop copyback
The detailed description for each command follows.
storcli /cx[/ex]/sx pause copyback
This command pauses a copyback operation. You can run this command only when there is a copyback
operation running.
Input example:
storcli /c0/e25/s4 pause copyback
storcli /cx[/ex]/sx resume copyback
This command resumes a paused copyback operation. You can run this command only when there is a paused
copyback process for the drive.
Input example:
storcli /c0/e25/s4 resume copyback
storcli /cx[/ex]/sx show copyback
This command shows the progress of the copyback operation in percentage.
Input example:
storcli /c0/e25/s4 show copyback
storcli /cx[/ex]/sx start copyback target=eid:sid
This command starts a copyback operation for a drive.
Input example:
storcli /c0/e25/s4 start copyback target=25:8
NOTE In the copyback commands, cx[/ex]/sx indicates the source drive and eid:sid indicates the
target drive.