Electrolux EHS 36020 U - Manual (Page 26)

26 electrolux what to do if …
What to do if …
If you are unable to remedy the
problem by following the above
suggestions, please contact your
dealer or the Customer Care De-
partment.
Problem Possible cause Remedy
The cooking zones will not
switch on or are not function-
ing More than 10 seconds have
passed since the appliance
was switched on Switch the appliance on again.
The child safety device is
switched on l Deactivate the child safety de-
vice (See the section “Child
safety device”)
Several sensor fields were
touched at the same time Only touch one sensor field
The sensor fields are partly
covered by a damp cloth or
with liquid Remove the cloth or the liquid.
Switch the appliance on again.
Automatic switch off has been
triggered
Switch the appliance on again
The residual heat indicator is
not displaying anything The cooking zone was only on
for a short time and is therefore
not hot If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
The automatic warm-up func-
tion is not switching on The highest heat setting is set
Ç
The highest heat setting has
the same power as the auto-
matic warm-up function
e
and number are displayed Electronics fault Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house’s wiring system)
If after switching on again,
e
is displayed again, call the
customer service department