1c) windows nt – Edimax Technology EW-7206GAb User Manual
Page 23
Wireless LAN Access Point Configuration
• DNS Configuration: Select Disable DNS.
• WINS Configuration: Select Disable WINS Resolution.
• IP Address: Select Specify an IP Address. Specify the IP Address and Subnet Mask
as following example.
9
IP Address: 192.168.2.3 (any IP address within 192.168.2.2~192.168.2.254 is
available, do not setup 192.168.2.1)
9
Subnet Mask: 255.255.255.0
8.
Reboot the PC. Your PC will now have the IP Address you specified.
1b) Windows 2000
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel
window will appear.
2.
Double-click Network and Dial-up Connections icon. In the Network and Dial-up
Connection window, double-click Local Area Connection icon. The Local Area Connection
window will appear.
3.
In the Local Area Connection window, click the Properties button.
4.
Check your list of Network Components. You should see Internet Protocol [TCP/IP] on
your list. Select it and click the Properties button.
5.
In the Internet Protocol (TCP/IP) Properties window, select Use the following IP address
and specify the IP Address and Subnet mask as following.
9
IP Address: 192.168.2.3 (any IP address within 192.168.2.2~192.168.2.254 is
available, do not setup 192.168.2.1)
9
Subnet Mask: 255.255.255.0
6.
Click OK to confirm the setting. Your PC will now have the IP Address you specified.
1c) Windows NT
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel
window will appear.
2.
Double-click Network icon. The Network window will appear. Select the Protocol tab from
the Network window.
3.
Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed,
click the Add button to install it now. If TCP/IP is installed, go to step 5.
4.
In the Select Network Protocol window, select the TCP/IP Protocol and click the Ok
button to start installing the TCP/IP protocol. You may need your Windows CD to
complete the installation.
5.
After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of
Network Protocols and then click the Properties button.
21