PLANET VIP-1680 User Manual

Page 11

Advertising
background image

NOTE: System initialization will turn some LEDs ON for a few seconds.

Í

Note

The Default LAN IP is

http://192.168.0.1

. Press RESET button

on rear panel over 5 seconds will reset the VoIP Gateway

to this default LAN/WAN IP address and Username/Password

function.

Rear Panel

Descriptions

WAN

The WAN port supports auto negotiating Fast Ethernet 10/100Base-T
networks. This port allows your voice gateway to be connected to an
Internet Access device, e.g. router, cable modem, ADSL modem, through a
CAT.5 twisted pair Ethernet cable.

LAN
(VIP-880/VIP-1680/
VIP-2480 series)
LAN 1 ~ LAN 4

(VIP-281/VIP-480 series)

The LAN port supports 1/4 10/100Base-T switch hub networks. These 1/4
ports allow your PC or Switch/Hub to be connected to the voice gateway
through a CAT.5 twisted pair Ethernet cable.

Reset

The reset button, when pressed, resets the cable voice gateway without
the need to unplug the power cord.
Note: (the VIP-880 series in Front Panel)

Power

The supplied power adapter connects here.

FXS

FXS port was connected to your telephone sets or Trunk Line of PBX.

FXO

FXO port was connected to the extension port of a PBX or directly

connected to a PSTN line of carrier.

Standard Telco 50 PIN

Connector (RJ-21)

It is a 50 pins RJ-21 connector for connecting to telephone patch panel.
Note: (the VIP-1680/VIP-2480 series only)

9-pin RS-232

(VIP-880/VIP-1680/

VIP-24

80 series)

Connecting VIP to a terminal emulator for configuring VIP
Note: (the VIP-880 series in Front Panel)


Connecting to the telephone patch panel (16-port/24-port model)

STEP 1: Attach the 25 port patch panel to the gateway through its RJ-21 connector.

STEP 2: The FXS LED indicators at telephone patch panel should be steady ON if the RJ-21 connector

is well connected to the gateway and the gateway is powered on.

Patch Panel LED

State

Descriptions

FXS

ON
Off

Telephone Set is On-Hook
Telephone Set is Off-Hook

FXO

On
Off

Line is not enabled
Line is In-using

Note: The FXO interface is designed for connecting to PBXs (extension line) or central office switches

11

Advertising
This manual is related to the following products: